Noob questions - Plate amp 2.1 kitchen speaker

[Steve1]

Hi Henry,
There have been quite a few similar builds posted on this forum, one of these might assist you and maybe give you some inspiration.

From Stack of Boards to Boombox (with Up2Stream Amp 2.1)

Hi all, As probably most of you, I had to find me a distraction during the last “do not leave the house” winter. Since I just setup my small hobbyist electronics lab and also was eager to learn more about woodworking, I did what most average guys would do in this situation - build a boombox . I decided to use the Dinas Boombox design of 123Toid as a starting point and to adjust it to my needs. The main deviation from the Dinas design was to not use a port but a passive radiator (8.5"). E…

My Up2Stream Plate Ammp 2.1 "BoomBox" project

[OSADDB_1] [OSADDB_2.PNG] Started planning a new BoomBox inspired by the JBL L75ms I plan to use: I have a Arylic Audio 2.1 amplifier (2x50W 4ohm + 1 x 100W 2 ohm), but would love using the new 2.1 plate amp in this project to get a clean build 1 x DD Audio 506d D4 subwoofer https://www.bassbrothers.no/.../basshoyt.../dd-audio-506d-d4 2 x DD Audio EX5.25 2 x Dayton Audio 6.5 Passive radiators Dayton Audio LBB-5v2 5 x 26650 battery module The DD Audio elements in the front and radiat…

Boombox Build with the new Up2Stream Plate Amplifier

So, I wanted to build a contemporary looking boombox for my own home and due to my lack of ability to do various wiring etc, I opted for the New ARYLIC Up2Stream plate amplifier for the project. A rough sketch and the rest was done on the fly! Made out of MDF (including the Kerfed sides) and with Dayton audios PS95-8 Full range drivers and the DSA135-8 Woofer. Weighing in just short of 10kg its a bit of a monster but, I am really happy with the sound and control with the 4stream app. Link to…

https://https://forum.arylic.com/t/diy-spearer-2-1-luna/2296