Amp 2.0 v4 Power Header - Pin Pitch?

DIY Products&Projects
1

I’m working on a multi-room amp “rack” that will allow quick install/disconnects of units, and would like to add a pin header to the unpopulated power connection on the boards.

I have not received my order for boards yet, but would like to get the pin headers and connectors on order now.

Does anyone know what the pin pitch is for the through-hole power connector location?
Is this 5.08mm?

image
image1906×1035 143 KB

2

Hi,
I don’t have that unit, but the most common size for those PCB mount screw terminals is 5mm or 5.08mm as you mentioned.

3

Thank you for the response. The board arrived earlier today and I was able to measure the pitch with my calipers. It is 5.08mm, or .2 inch pitch.

2 pin blocks ordered.