Component problem

Hi,

I managed to damage my Up2stream Pro V3 by knocking a component off - which I fixed. Now when I connect it to my microcontroller board by way of the button board connector I get a short across my 3v3 line. I noticed the component circled is measuring short - any ideas what it is? Unless its a 0R link or inductor I think its toasted.

Thanks

Any chance anyone with a Pro V3 can measure the resistance across this?

@stewc Stewart.

I’ll give it a go. give me a couple of days and will feedback.

Regards, Kevin

This is a magnetic bead. Can replace with 0 ohm resistance
Not have a big influence.